Raisecom RCMS2504-240 User Manual download pdf (Page 14)

Raisecom Technology Co., Ltd

Basic capacity

configuration

Empty Empty 4 channel E1

Max capacity

configuration

SUBM-4E1

(Provides 5

E1)

Empty 8 channel E1

10BaseT or

V.35sub-system

(occupied 5

E1)

10BaseT or

V.35sub-system

(occupied 8

E1) Multi service

configuration

100BaseT

(occupied 5

E1)

Empty

4 channel E1 +

multi-service

interface

• Basic capacity configuration (4 E1):

Both Slot 1 and 2 are empty.

• Maximum capacity configuration (8 E1)

Slot 1 is installed with SUBM-4E1 sub-module, which provides a DB37 male connector

for the 5

– 8

E1 channels. It can be installed with adapter to provide coaxial

connector. Slot 2 must be empty.

• Multi service configuration

When Slot 1 is installed with a 1 E1 interface sub-module (e.g. Ethernet to 1 E1 converter

sub-module, V.35 to E1 converter sub-module), it is actually the 5

E1 channel that be

occupied. If install a two-channel sub-module, it is actually the 5

and 6

channels that be

occupied.

When Slot 2 is installed with a 1 E1 interface sub-module, it is actually the 8

E1 channel

that be occupied. If install a two-channel sub-module, it is actually the 7

and 8

channels

that be occupied. Slot 2 does not support 4-channel sub-modules.

4.2.4. Power supply socket

When using AC power supply, 220V standard tri-phase socket shall be used.

When using DC power supply, -48V socket shall be used. The left pin is for -48V, the right

for 0V, and the middle for protecting ground.

4.3. DIP-Switch on the bottom panel

Please configure the DIP-Switch when power is off.

4.3.1. S1 to S4 introduction

There are 4 DIP-switches on the bottom. The dip-switch can be set

1 2 3 4

OFF

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments

Raisecom RCMS2504-240 User Manual Page 14

Comments to this Manuals

Related products and manuals for Network media converters Raisecom RCMS2504-240