Raisecom RCMS2201 User Manual download pdf (Page 10)

Raisecom Technology Co., Ltd

- 7 -

B． The both modules are installed in 16-slot 3U-high chassis, but only the host-site

chassis is equipped with network management module. The remote-site module

shall be set to “forced remote network management mode”. That is to say, the 8

switch shall be turned to ON.

4. Installation and Test

4.1 Inspect after Opening

Please first check if the models and part numbers are in consistence, and also check if the

equipments are damaged.

4.2 Preparation before Installation

 Carefully read this manual

 Prepare all kinds of the cable. Ensure that they are not short-circuited. Refer to

Appendix A for cable making.

 Ensure the pressure of power supply is in the tolerance range, the chassis is well

connected with the ground.

 Prepare the BERT and optical power meter for test of line quality.

 Place the equipment at stable and secure environment. Pay attention to the

requirements of the ambience.

4.3 Installation

This module can be installed into Raisecom’s dedicated 16-slot 3U-high chassis, 4-slot

1U-high chassis, and single slot chassis. Slowly insert the module into the slot to the end,

and fasten the fixing screw tightly.

4.3.1 Connecting the Cables

 E1 Interface:

RJ45 socket, 120 Ohm balanced signal.

1 2 ... 5 6 7 8 9 10 11 12 13 14

No comments

Raisecom RCMS2201 User Manual Page 10